Sound1.com
0,-
Lukk
Handlekurven er tom

Subtotal: 0,-

Mad Professor MP-FGC Forest Green Compressor

Art.nr: MP-FGC
2.495,-
Antall:

Produktet er midlertidig utsolgt. Dersom du ønsker å motta en epost når vi får det inn på lager, kan du legge igjen epostadressen din i skjemaet under.

Mad Professor
Leverandørlager. 10-12 virkedager til lager.

The Forest Green Compressor is fully tuneable for both bass and guitar to add compression or sustain to your sound.

There is extremely low noise throughout the range and a high overload margin, which allows also a wide dynamic input range at minimum distortion and noise. The tone knob allows you to fine-tune so that the compression can be very transparent and doesn't get in the way. When in sustain mode, you can achieve a very dynamic feel where you can get a touch-sensitive tone with longer sustain. The attack remains, making this pedal suitable for many styles of music and a very functional compressor.

The quality of the Forest Green Compressor is just like the other Mad Professor pedals in terms of quality and especially tone, dynamics and expression.




CONTROLS

LEVEL: In Compressor mode adjusts the overall volume and the FGC can be used even as a booster. In Sustain mode, the Level no longer adjusts total output but the level of the sustained part.

COMPR.: Sets the amount of compression and sustain. lower settings give mostly peak limiting, higher settings more compression and less touch sensitive response. at maximum the output will be heavily compressed, while still retaining clarity at almost infinite sustain. A good starting point for this control is a bit below center (ten o’clock) with most guitars.

TONE: Tone control on FGC is designed to fine-tune the compressed sound for most transparent tone and effect: adjust CCW for full range compression and set at noon for tighter sound with a little less bottom end and turn fully CW to slightly reduce upper treble.

COMPRESSOR/SUSTAIN SWITCH: Attack and decay times are carefully fine-tuned and internally set for swift attack and slow decay. Sustain/Compression switch set for Sustain the attack is preserved allowing dynamic touch and ease of playing as the FGC amplifies the decay and weaker parts. For standard compression set the mode switch to Compressor.


ELECTRICAL SPESIFICATIONS

Supply voltage range: 9 to 18VDC

Current consumption: 14mA at 9VDC

Input impedance: 1M Ohm’s

Output impedance: 20K Ohm’s

Max input: -10dBV

Hardwire true-bypass
 







CONTROLS

VOLUME: Sets the output volume.

DRIVE: Controls the amount of overdrive.

FOCUS: Controls how easily the circuit distorts as well as adjusting overall EQ. Turning CCW gives less distortion and a mellow effect, turning CW gives a slight treble boost and earlier distortion. Good starting point is 11 o’clock.


ELECTRICAL SPECIFICATION

Supply voltage range: 7,5 to 18VDC

Current consumption: 5 mA at 9VDC

Input impedance: 260K

Output impedance: 25K Ohm’s

Complete bypass (true bypass)


POWER REQUIREMENTS
6F22 9V battery or DC eliminator 2.1 mm plug center negative and positive sleeve.


NOTES
RRB is protected against wrong DC eliminator polarity. The fuzzy sound is a sign of low voltage. Maintain recommended voltage for best results.



CONTROLS

GTR/BASS: Switch GTR for the guitar and BASS for the bass or you can choose which positions suits better for your instrument.
SENSITIVITY: Sets the filter trigger level, tune this carefully to fit your guitar/bass output and your playing touch. You can further change the sensitivity from your guitar volume knob while playing.
BIAS: Controls the filter resonance frequency. When Sensitivity is turned fully off the Bias can be used as a sweepable filter.
RESONANCE: Controls the sharpness or Q-factor of the filter.
DECAY: Controls how fast the filter frequency falls back to resting point (that is set with the Bias control). This can be set fast (CW) so you get the wah effect on every note or slow for a more traditional auto wah sound.

ELECTRICAL SPECIFICATION
Current consumption: approx. 15 mA
Input impedance: 500K Ohms
Output impedance: 1K Ohms
Supply voltage: 9VDC
Max input: -20 dBV
Complete bypass and input of circuit grounded when in bypass.

Power Supply included: No

Trykk ENTER for å søke